Grinding ultrafine pulverizer principle, characteristics
The problem of ordinary ultra-micro gas flow is: high manufacturing cost, large investment, high energy consumption, too much powder processing, so that it is also subject to certain fields; difficult to make submicron Level products, product particle size is best in 10 um, and the output is sharply decreased at 10 um, and the cost is rapidly rising; the single-machine handling capacity of gas flow is smaller (both less than 1 ton hour, can not adapt to large-scale production needs; The wear problem of equipment processing and material is still plaguing equipment manufacturers and factory users.
Today, Yuepai powder equipment company explains the principle and characteristics of grinding ultrafine pulverizer. First of all from the most The basic knowledge begins, then introduces the host structure of the ultrafine pulverizer, let everyone learn.
1. Grinding ultrafine pulverizer
Grinding ultrafross mill, it is a Small crushers are mainly used to perform fine grinding because small size is small, so they can carry them with themselves, there is a wide range of uses in these industries such as pharmaceutical, food, feed, chemical, ceramics, metallurgical minerals. And to high toughness High-hardness materials are pulverized, specifically,:
High-quality, plant fiber: 8-20 um, 300-3000 mesh.
Hard, brittle materials: 1- 5 UM, 600-15000.
Power: 220V
Power: 250W
Rotation: 442rpm
Belt Transmission
Dimensions: 375 × 200 × 320mm
Weight: 26kg
Single Yield: 100-300 grams
2. Characteristics
(1) Can control polishing fineness by practice, the longer the practice, the higher the abrasive fineness of the material.
(2) Simple structure, easy to clean , Handling and installation is also very convenient.
Working principle
In the feed port, the material is put into the cylindrical comminution room,The rear material is pulled and cut against the material along the abrasive orbit, and the abrasive wheel is rolled and cut to achieve the purpose of pulverization.
4. Composition
The abrasive ultrafine pulverizer is mainly composed of a cylindrical crushed chamber, a polishing wheel and a polishing rail.
Second, the host structure of the ultrafine pulverizer
Division: adjustment of the air flow in the pulverizer, and also affects the discharge velocity.
Grinding tank: mainly engranging.
Disposable port: It is carried out, which can reach multiple layers. Pressure device: is a pressure.
Pressure rod locking device: After reaching the fixed pressure, the ground is fixed. Windselectual mechanism: Select the powder while taking the heat in the machine.
ALPA7 * 24-hour customer service hotline and 150+ service engineer is ready to stand at any time, there is any problem with the production line to complain, AlPA will give technical advice within 30 minutes, give back to complaints within 12 hours, within 24 hours Provide a clear solution, to arrive at the fault site within 3 days (foreign 10 days).
