The reason for strong vibration of gas flow crusher

　　The problem of ordinary ultra-micro gas flow is: high manufacturing cost, large investment, high energy consumption, too much powder processing, so that it is also subject to certain fields; difficult to make submicron Level products, product particle size is best in 10 um, and the output is sharply decreased at 10 um, and the cost is rapidly rising; the single-machine handling capacity of gas flow is smaller (both less than 1 ton hour, can not adapt to large-scale production needs; The wear problem of equipment processing accuracy and material is still plaguing equipment manufacturer and factory major users.In general, the cause of strong vibration in the airflow pulverizer is:

　　(1) Spiral feeding When the airflow pulverizer is running, occasionally occasionally vibration, the reason for this is that the machine is not in place, the screw on the spiral feeder component does not reinforce, and after this, it should immediately check if the device is installed correctly.

　　(2) Nozzle unstoppable nozzle is a key portion of the material to collide with each other. If there is a problem at the nozzle, it will cause a strong vibration of the machine, resulting in errors in the production process, which triggered a series of The problem, even causes pollution.

　　(3) Bearings, the spindle damage has no replacement spindle, bearing, resulting in wear of the accessory, is the most common factor in the machine, and should be replaced immediately and fastened.

　　(4) Existing vocals in the abdominal gas flow crusher in the airflow mill is due to the inside of the airflow pulverizer

　　In terms of quality inspection, ALPA powder technology is particularly strict, and it is well known, one The production and manufacturing process of ultrafine powder is often up to hundreds. The airflow pulverizer is a special equipment, and there is a flaw in any of the production process. Therefore, AlPa powder technology is producing the whole process of production A total of seven step stop points were established, which were strictly checked by different engineers. They were independent of each other and supervised each other, and they found problems and solve problems in time. Any detail is unqualified, they can't enter the down process, This is the quality monitoring of ALPA powder technology to the whole process of production.