Remember! Three points needed to pay attention to using small air current crushers

　　Airflow mill tells us that the gas flow mill is still used in the industrial industry, such as flat air flow, other types of gas flow such as spray gas flow, fluidized bed gas flow grinding. Moreover, gas flow grinding is also widely used because gas flow mills themselves have more particular functions, which can save a large amount of manpower, and can also effectively improve labor efficiency, so the use of gas flowing is so common and wide.Want to reduce the failure incidence of

　　small airflow pulver, extend its service life, then operators must pay attention to the following three points when using the airflow pulverizer:

　　(1 Before the pulverization, the pulverizing cavity of the pulverizer should be checked, whether it is empty, there is foreign matter, if it should be removed in time. When there is no problem everything, it is possible to turn on the power.

　　(2) Let the pulverized air machine run from 1 to 2 minutes, and then feed, but pay attention to the amount of feeding should not be too much.

　　(3) When the crusher is working, it cannot be extended into the pulverized cavity, which is very dangerous. Moreover, the working current of the pulverizer cannot exceed 15A.

　　Only the correct operation and the right way to maintain the performance of the small airflow pulverizer is in the best state, so although Xiaobian is talking about some small details, it is also necessary. Everyone is noticed.

　　In terms of quality inspection, ALPA powder technology is particularly stricter. It is well known that a manufacturing process of a ultrafine powder is often up to hundreds. As a special equipment, the airflow pulverizer is like a special process, and it is possible to make a big disaster. Therefore, ALPA powder technology has established seven process stop points in the production process, which is strictly controlled by different engineers, and each other is independent and mutual supervision, and it is timely discovery and solve the problem. Any detail is unqualified, it is unable to enter the proceeding process, which is the quality monitoring of AlPa powder technology to the production process.