Ultrafine pulverization of super hard and material recommends airflow pulverizer

　　When the airflow mill is used, the advantage is that the wear surface is relatively small, and the material is not easy to deposit. The impact force is also very large, and the efficiency of pulverization equipment and the fineness of the fineness are the same. It is also very widely used in the range of use. It is also very fine. It is also a typical material. It is also a super hard diamond. The high purity crushing requirements are also very high, and it is usually used in many industries. It is very large for drugs. importance.As one of the main equipment of modern mineral ultrafine pulverization, the airflow pulverizer has been a successful use case in minerals, chemicals, coal and other industries. Due to the development of society, the degree of crushing of many superhard materials has no longer satisfying the demand for production, and the use of gas current pulverizer can overcome the requirements of the particle size, which is the finest fine.

　　How does the airflow pulverizer

　　do the ultrafine smashing of superhard materials? Unlike the general airflow pulverizer, the airflow pulverizer is not only the centrifugal force of the graded rotor, but also from the centrifugal force generated by the gas flow, when the centrifugal force of the material is greater than the heart, the thick material will be brought back. The pulverization room was pulverized again.

　　Airflow pulverizer is an update to the conventional fluidized bed airflow pulverizer, and the gas flow pulverizer has high yield, green environmental, high efficiency, and equipment. The feature of small wear, multi-purpose. Ultrafine powder for drying,

　　high purity, low temperature, etc., widely used in chemical, mining, abrasive, battery materials, refractory, non-metallic mine, metallurgy, building materials, pharmaceutical, food, pesticides , Feed, new materials, environmental protection and other industries and ultra-fine pulverization, dissipation and particle shape of various dry powder materials.

　　The processing equipment requires different lining materials according to the material, from the injection end to the discharge end, the amount of metal foreign matter is controlled at the PPM level, in the material and internal protection means The standard of zero pollution of the processing material can be achieved. For those with toughness, viscosity, thermal or other materials, AlPA can provide a variety of machining environments and processing methods to meet customer needs.