Correctly operating the airflow crusher, you should pay attention to these points

　　Paint, coating, solid components in dye can be made into high performance high adhesion, and new products can be made after airflow milling ultrafine. In papermaking, plastic and rubber products, solid fillers such as: calcium carbonate, titanium oxide, silicon oxide can produce high-performance copper sheets, plastics and rubber products.

　　Master the operation process of the airflow pulverizer is very important. For how it is safely operated, it is not clear for many people, so we need to learn to understand, master the operation of the airflow crusher It is crused to the airflow pulverizer itself.

　　It is possible to check all the lines, electrical components, etc. of the airflow pulverizer, and whether it is possible to work. Whether the machine is grounded, so that the housing is powered by electric shock. Whether the machine spindle has a card death, if it should be handled in time. During the operation, there is an abnormal situation, and if there is a stop check.

　　Check the blade, is tightened, whether the blade gap can reach the specified standard. Before using the pulverizer, check the working room is enough or shorts, if it should be removed in time.

　　After the pulverizer is running normally, it will begin to start the feed. The pulverizer should stop the feed before the shutdown. When the machine is completely discharged, it can be stopped.

　　The feed should be uniform and cannot be excessive to avoid increasing the burden on the machine. During the operation, the airflow pulverizer cannot be cleaned, maintenance, etc.

　　The main reason for the high oil temperature of the lubrication system is: (1) friction disk surface or oil tank abnormally wear; (2) The oil quality of the lubricant does not meet the requirements; (3) The cooling system does not work; (4) The lubricant flow is less.

　　Crusher Since the 84 "hydraulic cone oil temperature protection range is 21 ~ 54 ° C, the main motor is highled under the control of the oil temperature gauge, the temperature is high in summer. The two finely broken cone is broken due to the load weight, the oil temperature is high, and the oil temperature will be close or more than 54 ° C for a while. In order to protect the equipment, only people are parking or any automatic tripping, and each trip After the interior friction When you cool to a certain temperature, you can drive again, causing multiple parking, which seriously restricts the production capacity of the cone, affecting the improvement of the system, and the 84 "hydraulic cone crusher cooling systemRow.

　　It can be achieved by analyzing and transformation: reducing frequent opening, parking, and improving the production capacity and system storm effect due to high oil temperature.

　　Cause Analysis Due to the high temperature in summer, the cone is broken, resulting in a critical value of the oil temperature of the lubrication system, often reaching or more than 54 ° C, the critical value of the oil temperature meter, causing a class system to open, parking, Severely restrict the normal production capacity of conical, affecting the improvement of system calendar.

　　The four seasons change impermanence, we should choose a residence with a safe, energy saving, environmental protection, green and green, and our development of the gas flow crusher does not stop in quality assurance, and there is also a result of high-performance in energy conservation, and Technical and innovation constantly improve their product development.

　　From the question consultation, AlPA provides customers with the most professional solutions and the most comprehensive solution, and assist customers in planning construction programs to provide customers with the most professional "babysitted" private order. Service. ALPA has served more than 3,000 customers at home and abroad, and more than 100 countries and regions in the market are spread all over the market, non-, European, US and Oceania. Acclaim.